Maintenance
Basic cleaning
Many everyday stains can be treated with a simple cleaning of water, soap, a cloth, and rinsing and drying.
Deep cleaning
For some stains is important to use a microfiber sponge with plenty of dishwashing soap or all-purpose detergent with warm water, you can also use bleach.
Learn more about Marlik® Solid Surfaces
The surface does not absorb spills. If it does in an extreme circumstance, and a stain is left, clean-up would be:
A grease remover detergent or dishwashing soap.
An abrasive microfiber sponges.
Cold or sometimes hot water.
When stains and streaks don’t go away, and previous cleanings did not turn out as expected
Then it´s time to ask Marlik® for maintenance. You can find more information on this page.
Marlik® Solid Surfaces are resistant to scratches and high temperatures, however they are not resistant to direct heat
Heat resistant: The solid surfaces can withstand a maximum of 392°F (200°C). If this temperature is exceeded, damage may occur
Some aggressive chemicals such as acids can damage the surface, in this case, it is important to immediately rinse spills such as wine, mustard, permanent marker, or others.
Avoid cutting food directly on the surface, it is always advisable to use a cutting board.
For cigarette burns, use the microfiber sponge.
Maintenance
For wear and tear on surfaces resulting from daily use over the years, remember that you have the Marlik® maintenance service to keep your solid surfaces as good as new.
Repairing Marlik® Solid Surfaces
From hard impacts, burns or Cracks is very simple, as one of our expert technicians will replace only the damaged part.
A specialist will be happy to advise you
To know in detail the characteristics of the Marlik® warranty,
please contact Marlik´s customer service department
by telephone and mail.
Material
Tailor-made solutions
Maintenance
care
Your project
Installation
